THE SWG POWER VENTER

The SWG is the safest, most efficient power venter available today. It combines the motor, blower and vent hood in one complete, easy to install unit that significantly reduces motor noise. The SWG utilizes 100% negative pressure to effectively vent oil and gas-fired furnaces, heaters, boilers, gas-fired water heaters and fireplaces through the sidewall. Models are available for residential, commercial and industrial use. Some models are CSA listed and AGA approved. All are ETL listed. The standard SWG Power Venter is designed for walls up to 8" thick. PEK extension kits allow the SWG to be installed in walls up to 16" thick. The PEK kit includes the inner/outer pipe extension, air flow damper and one foot of 1/4" aluminum tubing. It is available for models SWG-4 through SWG-8.

 

TYPE MG-1 DRAFT CONTROL

A double-acting control for gas-fired furnaces and boilers. It is widely used for conversion burner installations, gas draft-induced appliance operation with mechanical draft inducers or sidewall power venters, gas atmospheric appliances where a draft hood cannot be installed, and can improve combustion stability and draft on many gas atmospheric installations with venting problems. The MG-1 provides precise, accurate control of drafts at levels higher than permitted by a standard draft diverter... a frequent requirement with gas. Because it is double-acting, it opens out to relieve positive vent system pressures as low as .001". Draft adjustments using weights are simple and accurate from .01" to .1".

 

PVG/PVO POWER VENTERS

The indoor mounted PVG and PVO Power Venters provide an economical power venting system for gas and oil appliances. All controls are built into these units. A Vent Hood is required to terminate the vent system.

 

 

DRAFT INDUCERS

Field Draft Inducers solve the drafting problems caused by short chimneys, undersized flue pipes and negative building pressures. Draft Inducers are designed for easy installation in a wide variety of applications, including oil or gas fired furnaces, water heaters and boilers. For venting a single appliance, a Draft Inducer Proving Switch (DIP-1) is recommended.